Please follow the instructions below to determine the size you require for each of our products.

If you'd like some help don't be afraid to ask.

Measuring Collars

To find the right size collar or cuffs to suit you only takes a couple of easy steps...

First, using a tailors tape measure - one of the cloth/tape variety - place it around the neck being measured.

Typically you will want to measure near the base of the neck

Then... keeping the tape in place put two fingers between the tape and skin and make a note of the size.

This will give you the snuggest fit allowing normal movement of the neck.

Remove the fingers and keeping the tape in place adjust it to see which fit you'd prefer...the snug fit described above or something a little looser.

Take a note of the measurement you've chosen and send us the details with your order.

Measuring Cuffs & Anklets

To measure for cuffs or anklets you need to take two measurements;

First measure your wrist or ankle at its narrowest point.

Then you need your slip size. For hands place your thumb on the base of you little finger. Then measure around the hand across the base of the thumb.

So long as the cuff is larger than your wrist but smaller than your slip size, and thus too small to slip off, you have a working cuff.

For ankles measure around the heel to determine the slip size.

Please note that due to the nature of the construction of the cuffs, the smallest wrist or ankle size we can cater for is 7 inches

Unlike necks, wrists and ankles you can squeeze waists.

You need to measure the bare waist exactly and if you are looking for a snug fit take an inch off.

** Wraith Belts are Perfect for Locking a Corset On! **

To measure for CORSETS just measure the corset on the sub/slave and we'll make a steel band that'll stop them loosening the lacing!

Don't forget to send us your measurement with your order... every item is made to order and not sending it will delay delivery